XZR8® 鑫眾潤
Holset 1004349679 渦輪增壓器總成

Holset 1004349679 渦輪增壓器總成


極速免費配送
三年官方質保
90天無憂退換
24/7 全天候客服
渦輪增壓器型號Holset HX55
壓縮機誘導器直徑76.2 mm
壓縮機擴壓器直徑110 mm
渦輪輪直徑88 mm
渦輪機外殼A-R1.15
洩壓閥驅動Pneumatic / Electronic (Application Specific)
油口螺紋M18 x 1.5
油出口法蘭4-Bolt Pattern
壓縮機出口直徑4 inch (101.6 mm)
渦輪進氣法蘭T4 Divided Volute
旋轉方向Clockwise (Viewed from Compressor Side)
平衡等級G2.5 / ISO 1940
淨重30 kg
包裝尺寸45 × 45 × 45 cm

製造號

  • 1004349679
  • HX55
  • 3593606
  • 4041873

主機廠號

  • 1004349679
  • 612630060001

發動機號

  • Weichai WP10
  • Weichai WP12
  • Weichai WP13
  • Cummins M11
  • Cummins ISM

互換號

  • 3593606
  • 4041873
  • HX55
  • NP-0736CHRA

適配車型

  • Sinotruk Howo 371
  • Sinotruk Howo 420
  • Shacman F3000
  • Faw J6P
  • Shantui SD22 Dozer
  • XCMG XE215 Excavator
  • LiuGong CLG922 Excavator
This turbocharger assembly utilizes the Holset HX55 compressor and turbine frame configuration, engineered for high-boost pressure ratios required by Weichai WP10 and WP12 heavy-duty diesel platforms. The unit features a forged milled compressor wheel (FMW) for improved aerodynamic efficiency and burst containment margin. The turbine housing integrates a divided volute design to optimize pulse energy utilization from the exhaust manifold, reducing turbo lag and improving transient response. The center housing rotating assembly (CHRA) incorporates a fully floating bronze bearing system with piston ring seals on both turbine and compressor ends, lubricated and cooled by engine oil supply. The wastegate actuator is calibrated to OEM boost pressure specifications for the target engine calibration. This assembly serves as a direct bolt-on replacement for the OEM part number 1004349679, requiring no modifications to oil feed, drain, or intake/exhaust piping interfaces. Cross-reference interchange data confirms compatibility with Holset service part numbers 3593606 and 4041873, commonly associated with Cummins M11 and ISM platforms sharing the HX55 architecture. Verification of the engine nameplate and turbocharger nameplate (located on the compressor housing) is required prior to installation to ensure correct trim matching.