XZR8® 鑫眾潤
小松 708-2L-06470 液壓泵缸體

小松 708-2L-06470 液壓泵缸體


極速免費配送
三年官方質保
90天無憂退換
24/7 全天候客服
泵型號HPV95 / HPV95H / HPV95A
排量區域195 cc/rev
最大工作壓力34.3 MPa
柱塞數量9
活塞排列Axial
材質High-Strength Alloy Steel
表面處理Case Hardened (HRC 58-62)
花鍵標準16-Tooth
花鍵標準114-Tooth
零件重量2.5 kg
包裝尺寸25 × 15 × 15 cm

製造號

  • 708-2L-06470
  • 708-2L-06480
  • 708-2L-06360
  • 708-2L-04040
  • 708-2L-33110
  • 708-2L-33150

主機廠號

  • 708-2L-06470
  • 708-2L-06480
  • 708-2L-06360
  • 708-2L-04040
  • 708-2L-33110
  • 708-2L-33150
  • 708-2L-04141

發動機號

  • Komatsu SAA6D107E-1
  • Komatsu 6D102
  • Komatsu 6D95
  • Komatsu 4D102
  • Komatsu 4D95

互換號

  • UHPW770001
  • 7045
  • HPV95-CB-06470

適配車型

  • Komatsu PC200-6
  • Komatsu PC200-7
  • Komatsu PC200-8
  • Komatsu PC200LC-8
  • Komatsu PC210-7
  • Komatsu PC210-8
  • Komatsu PC220-6
  • Komatsu PC220-7
  • Komatsu PC220-8
  • Komatsu PC270-8
  • Komatsu PC120-6
  • Komatsu PC130-7
  • Komatsu PC230-8
  • Komatsu PC240-8
The 708-2L-06470 cylinder block is a critical rotating group component designed for the Komatsu HPV95 variable displacement axial piston pump. It houses nine pistons in a precision-bored barrel, converting mechanical shaft rotation into hydraulic flow through controlled displacement variation. Manufactured from high-strength alloy steel with case-hardened running surfaces, the block maintains dimensional stability under peak pressures of 34.3 MPa. The component interfaces directly with the valve plate and piston shoes, requiring exact flatness and surface finish to minimize internal leakage and maximize volumetric efficiency. This part serves as a direct replacement for OEM numbers 708-2L-06470, 708-2L-06480, 708-2L-06360, and 708-2L-04040 across HPV95, HPV95H, and HPV95A pump variants. Compatibility spans Komatsu PC200-6, PC200-7, PC200-8, PC210-7, PC210-8, PC220-6, PC220-7, PC220-8, PC270-8, PC120-6, and PC130-7 excavators equipped with the HPV95 main pump. The cylinder block is engineered to match the 95 cc/rev per section displacement and 16-tooth (PC200-7) or 14-tooth (PC200-8) drive spline configurations. Installation requires verification of pump nameplate and control valve type (PC/LS/EPC) to ensure correct barrel orientation and port timing alignment.