XZR8® 鑫眾潤
濰柴 612630110348 增壓器進油管總成
濰柴 612630110348 增壓器進油管總成 - Image 2
1 / 2

濰柴 612630110348 增壓器進油管總成


極速免費配送
三年官方質保
90天無憂退換
24/7 全天候客服
零件型別Turbocharger Oil Feed Pipe / Oil Inlet Line
交叉參考612630110258
渦輪增壓器型號GTA42
發動機應用Weichai WP12 / WP13 Series
材質High-Temperature Alloy Steel Tubing
接頭型別Banjo Bolt (Both Ends)
花鍵螺栓螺紋M14 x 1.5 (Typical)
最大工作壓力1.5 MPa / 217 PSI
密封方式Copper/Aluminum Crush Washer
安裝扭矩25-30 Nm
淨重0.45 kg
包裝尺寸35 × 15 × 5 cm

製造號

  • 612630110348

主機廠號

  • 612630110348
  • 612630110258

發動機號

  • Weichai WP12
  • Weichai WP13
  • Weichai WP12.4
  • Weichai WP13.4

適配車型

  • Sinotruk Howo 371
  • Sinotruk Howo 420
  • Sinotruk Howo A7
  • Sinotruk Howo T7H
  • Sinotruk Howo T5G
The 612630110348 turbocharger oil feed pipe is a critical lubrication system component designed to supply pressurized engine oil to the turbocharger bearing cartridge. It is engineered for Weichai WP12 and WP13 series heavy-duty diesel engines equipped with GTA42 frame turbochargers, commonly installed in Sinotruk Howo tractor and dump truck platforms. Constructed from high-temperature resistant steel tubing with precision-formed banjo fittings at both ends, the assembly includes integrated sealing surfaces for copper or aluminum crush washers. The routing geometry matches the original equipment installation path between the engine block oil gallery port and the turbocharger center housing inlet. The component withstands continuous operating pressures up to 1.5 MPa and peak thermal cycles exceeding 250°C at the turbocharger connection point. This part number cross-references to Weichai drawing 612630110258 and applies to GTA42 turbocharger configurations. Installation requires torque tightening of banjo bolts to 25-30 Nm with new sealing washers to prevent oil leakage and ensure bearing lubrication integrity.